Use phone in android studio developer how to#
Use phone in android studio developer install#

Run the android.bat application in the oolsĭirectory. These are the steps to set up a Google Nexus deviceĪnd are provided as a reference.

Use phone in android studio developer install#

It may be necessary to install some extra drivers before a WindowsĬomputer will recognize an Android device connected by USB. This step is not necessary for macOS just connect the device to the In this case you may want to verify that USB drivers are installed. In some cases you might find that your device cannot connect to the computer. The following command at the command prompt to see what is connected: adb devices Regardless of how the devices are connected, you can issue It's possible to request ADB to list the devices that are connected to theĬomputer. USB mode with the following command: adb usb When you're finished debugging via WiFi, it's possible to reset ADB back to Once this command finishes the Android device is connected to the computer via WiFi. Prompt, type the following command: adb tcpip 5555Īfter this command is issued, your computer will not be able to listen to devices that are connected via USB.ĭisconnect the USB cable connecting your device to your computer.Ĭonfigure ADB so that it will connect to your Android device on the port that was specified in step 1 above: adb connect 192.168.1.28:5555 Next, restart ADB so that it using TCP on port 5555. On some versions of Android the IP address won't be listed thereīut can be found instead under Settings > About phone > Status.Ĭonnect your Android device to your computer via USB. This will open a dropdown showing information about the networkĬonnection, similar to what is seen in the screenshot below: Then tap on the WiFi network that the device is connected to, and then tap onĪdvanced. Out the IP address is to look under Settings > Network & internet > Wi-Fi, To setup your environment to debug over WiFi complete the following stepsĭetermine the IP address of your Android device. Toĭo this, both the device and the computer must be on the same WiFi Possible to reconfigure it to use TCP/IP instead of USB. Is configured to communicate with an Android device via USB. This technique requires more effort but could be useful when the device is too far from the computer to remain constantly plugged-in via cable. It is possible to connect an Android device to a computer without using a USB cable, over WiFi. You can also check Always allow from thisĬomputer to prevent requiring this prompt each time you connect the device. You will receive a prompt to trust the computer on your device if you have The final step is to connect the device to the computer. This is the place to enable developer options such as USB debugging and System, open it to reveal developer settings: Once the Developer Options tab is available under Settings > Navigate to Settings > Developer Options and enable USB Debugging. Navigate to Settings > System > Developer Options and enable USB Debugging.

Navigate to Settings > System > Advanced > Developer Options and enable USB Debugging.

This also varies based on the Android version.

Tap Build Number 7 times until You are now a developer! is visible.Īfter enabling developer mode on your device, you must ensure that USB debugging.

Since version 4.2, and enabling them can vary based on the Androidįor Android 9.0 and higher, debugging is enabled by following Developer options on Android have been hidden by default

You will need to enable debugging and connect the device to the computer.Įach of these steps will be covered in more detail in the sectionsĪ device must be enabled for debugging in order to test an AndroidĪpplication.

Use phone in android studio developer how to#

This article explains how to setup an Android device and connect it to a computer so that the device may be used to run and debug Xamarin.Android applications.Īfter testing on an Android emulator, you will want to see and test your apps running on an Android device.